EasyManuals Logo

Denon AVR-X1700H User Manual

Denon AVR-X1700H
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #190 background imageLoading...
Page #190 background image
Procedure for speaker settings
(Audyssey
®
Setup)
.
Finish
Check
Calculation & Store
Measurement
Preparation
1
Attach the Sound calibration microphone to the
supplied microphone stand or own tripod and install it
at the main listening position.
When installing the Sound calibration microphone, point the tip of
the microphone toward the ceiling and adjust the height to match the
height of the ears of a listener in a seated position.
2
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
n
When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment
and crossover frequency setting.
n
When using a subwoofer without a direct mode
Make the following settings:
0
Volume : 12 o’clock position
0
Crossover frequency : Maximum/Highest Frequency
0
Low pass filter : Off
0
Standby mode : Off
Contents Connections Playback Settings Tips Appendix
190
Front panel Display Rear panel Remote Index

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X1700H and is the answer not in the manual?

Denon AVR-X1700H Specifications

General IconGeneral
Supported radio bandsAM, DAB, DAB+, FM
Radio Data System (RDS)Yes
Internet radio services supportedAmazon Music, Deezer, Pandora, SIRIUS Internet Radio, Spotify, Tidal, TuneIn
Receiver typeSurround
Pre-out channels0.2
Input sensitivity200 mV
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)98 dB
Total Harmonic Distortion (THD)10 %
Power output per channel (1KHz@6 Ohm)175 W
Power output per channel (20-20KHz@8 Ohm)80 W
HDMI in6
Remote (IR) input1
Composite video in2
Digital audio coaxial in-
HDCP version2.3
Product colorBlack
Audio decodersDTS:X, Dolby Atmos, DTS Virtual:X, Dolby Surround, Dolby TrueHD
Center speaker impedance16 Ω
Speakers connectivity typeClamp terminals
Audio formats supportedAAC, ALAC, DSD, FLAC, MP3, WAV
Supported graphics resolutions7680 x 4320
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)430 W
Package weight10600 g
Package depth435 mm
Package width523 mm
Package height232 mm
Weight and Dimensions IconWeight and Dimensions
Depth339 mm
Width434 mm
Height151 mm
Weight8500 g

Related product manuals