EasyManuals Logo

Denon AVR-X1700H User Manual

Denon AVR-X1700H
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #237 background imageLoading...
Page #237 background image
Desired sound does not come out
The volume does not increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. (v p. 170)
0
Appropriate volume correction processing is performed according to the input audio format and settings, so the volume may not reach the upper limit.
No sound comes out with the HDMI connection.
0
Check the connection of the HDMI connectors. (v p. 50)
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output from the TV, set “TV”. (v p. 176)
0
When using the HDMI Control function, check that the audio output is set to the AV amplifier on the TV. (v p. 142)
When an eARC function-compatible television is connected, television audio is not output from the speaker connected to this unit
0
eARC function settings may be required depending on the eARC function-compatible television you are using. Make sure eARC is set to on if this
setting exists on your television. For more information, check your television’s owner’s manual.
0
Make sure the input source of this unit is “TV Audio”.
0
The eARC function does not operate when the HDMI input connector is set to the “TV Audio” input source. To enable eARC function operation, remove
the HDMI input connector setting, then restart this unit and the television. (v p. 185)
No sound comes out of a specific speaker.
0
Check that speaker cables are properly connected.
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. (v p. 199)
0
Check the “Assign Mode” setting in the menu. (v p. 198)
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and subwoofer.
0
Audio is not output from the surround back speaker if “Sp.Virtualizer” is set to “On” when “Speaker Config.” - “Surround Back” is set to “1 spkr” in the
menu. (v p. 166)
Contents
Connections Playback Settings Tips Appendix
237
Front panel Display Rear panel Remote Index

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X1700H and is the answer not in the manual?

Denon AVR-X1700H Specifications

General IconGeneral
Supported radio bandsAM, DAB, DAB+, FM
Radio Data System (RDS)Yes
Internet radio services supportedAmazon Music, Deezer, Pandora, SIRIUS Internet Radio, Spotify, Tidal, TuneIn
Receiver typeSurround
Pre-out channels0.2
Input sensitivity200 mV
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)98 dB
Total Harmonic Distortion (THD)10 %
Power output per channel (1KHz@6 Ohm)175 W
Power output per channel (20-20KHz@8 Ohm)80 W
HDMI in6
Remote (IR) input1
Composite video in2
Digital audio coaxial in-
HDCP version2.3
Product colorBlack
Audio decodersDTS:X, Dolby Atmos, DTS Virtual:X, Dolby Surround, Dolby TrueHD
Center speaker impedance16 Ω
Speakers connectivity typeClamp terminals
Audio formats supportedAAC, ALAC, DSD, FLAC, MP3, WAV
Supported graphics resolutions7680 x 4320
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)430 W
Package weight10600 g
Package depth435 mm
Package width523 mm
Package height232 mm
Weight and Dimensions IconWeight and Dimensions
Depth339 mm
Width434 mm
Height151 mm
Weight8500 g

Related product manuals