Denon AVR-X2200W Owner's Manual

Smart Menu function
This function can be used to configure the settings of this unit, select an
input source and set Tuner and Internet Radio stations using the TV
remote control.
1
Enable the HDMI control function of this unit and the
TV. (v p. 160)
2
Set “Smart Menu” to “On” on this unit. (v p. 163)
3
Select “AV Receiver” in a TV menu such as “Input”z or
“Operate Connected HDMI Device”z.
The Smart Menu of this unit is displayed on the TV.
0
This unit can be operated with the TV remote control while the
Smart Menu is displayed.
z
The selection method differs depending on your TV.
.
Smart Menu
Quick Select 4
Help
Quick Select 3Quick Select 2Quick Select 1
Smart Menu
Setup MenuSound ModeSource
Now Playing
Blu-ray
o
Now Playing
Enjoy content from the input source currently selected on this unit.
o
Source
Switch the input of this unit.
If you select “Online Music”, “iPod/USB” or “Tuner”, you can continue
to operate this unit using the TV remote control.
o
Sound Mode
Change the sound mode of this unit.
You can select from the following three sound modes.
Surround:
Surround sound playback according to
the input signal.
Stereo: Stereo playback.
Multi Ch Stereo: Multi-channel stereo playback.
Contents Connections Playback Settings Tips Appendix
125
Front panel Display Rear panel Remote Index

Denon AVR-X2200W Specifications

General

Channels	7.2
HDMI Inputs	8
HDMI Outputs	2
Dolby Atmos	Yes
DTS:X	Yes
Wi-Fi	Yes
Bluetooth	Yes
4K Ultra HD Pass-through	Yes
Audyssey MultEQ XT	Yes
HDCP Support	2.2
AirPlay	Yes
Ethernet	Yes
Phono Input	Yes
Total Harmonic Distortion	0.08% (20Hz-20kHz)
HDMI Version	2.0a
4K Support	Yes
HDR Support	Yes
Dimensions (W x H x D)	434 x 167 x 339 mm
Power Output per Channel	95W (8 ohms, 20Hz - 20kHz, 0.08% THD)
USB Input	1
Frequency Response	10Hz - 100kHz
Inputs	8 HDMI, 2 component
Outputs	2 HDMI, 1 composite, 1 component