Name: Denon AVR-X2200W
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Dolby Speaker Setup

Set the distance between the Dolby Atmos Enabled speaker and the

ceiling.

0.90 m - 3.30 m / 3.0 ft - 11.0 ft

(Default : 1.80 m / 6.0 ft)

This can be set when “Front Dolby” or “Surround Dolby” is set to “Large” or

“Small” in “Speaker Config.”.

Set Defaults

The “Distances” settings are returned to the default settings.

Levels

Set the volume of the test tone to be the same at the listening position

when it is output from each speaker.

Test Tone Start

A test tone is output from the selected speaker.

While listening to the test tone, adjust the volume output from the

selected speaker.

–12.0 dB – +12.0 dB (Default : 0.0 dB)

The set “Levels” are reflected in all sound modes.

If you wish to adjust the channel level for each input source, carry out the

settings in “Channel Level Adjust”. (v

p. 107)

When headphones are connected to the PHONES connector on this unit, you

cannot set “Levels”.

Set Defaults

The “Levels” settings are returned to the default settings.

Contents

Connections Playback Settings Tips Appendix

192

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X2200W

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X2200W and is the answer not in the manual?

General