Name: Denon AVR-X2200W
Brand: Denon
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Network

To use this unit by connecting it to a home network (LAN), you must configure network settings.

If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).

When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enter

information about your home network (LAN) such as the gateway address and subnet mask, etc.

Information

Display network information.

Friendly Name / Connection / SSID / DHCP / IP Address / MAC

Address

MAC Address is required to create a vTuner account.

Connection

Choose whether to connect the home network to a wireless LAN or a

wired LAN.

When connecting to the network using wired LAN, select “Wired

(Ethernet)” after connecting a LAN cable,

When connecting to the network using wireless LAN, select “Wireless (Wi-

Fi)” and configure the “Wi-Fi Setup”. (v

p. 197)

Wi-Fi

You can stop the Wi-Fi function when connecting this unit to the

network using Wired LAN.

Enabled

(Default):

The Wi-Fi function is used.

Disabled: The Wi-Fi function is stopped.

Contents Connections Playback Settings Tips Appendix

196

Front panel Display Rear panel Remote Index

Other manuals for Denon AVR-X2200W

Questions and Answers:

Need help?

Do you have a question about the Denon AVR-X2200W and is the answer not in the manual?

General