Denon DAP-2500A - REMOVAL OF EACH SECTION; Component Removal Procedures

SEO A P-2500A
REMOVAL OF EACH SECTION
1. Top Cover Removal
Remove 10 screws and take out the Top Cover as
per the arrow shows.
2. Front Panel Removal
Remove 6 screws and draw out the Front Panel as
per the arrow shows.
3. Front Sub-panel Removal
1 Remove screw ®, slide the chassis frame
toward arrow direction, and release the hook
from the chassis frame.
2 Unsecure 2 screws (purposing to make a gap
above the bottom plate so that the hook of
Front Sub-panel releasing from the chassis) and
2 screws ©. then release the hooks from the
both sides and detach the Front Sub-panel.
4. Rear Panel Removal
Unfasten 4 screws (A) and 10 screws (8), then
detach the Rear Panel.
26
Top Cover
Front Sub-panet
Rear Panel