Denon DBT-3313UD

65
Specifications
n Performance
Signal format : NTSC, PAL
Applicable discs /memory device : (1) BD-Video disc :
12 cm, 1 side, 1 layer; 12 cm, 1 side, 2 layers
(2) DVD-Video / DVD-Audio disc :
12 cm, 1 side, 1 layer; 12 cm, 1 side, 2 layers /
12 cm, 2 sides, 2 layers (1 side, 1 layer)
8 cm, 1 side, 1 layer; 8 cm, 1 side, 2 layers /
8 cm, 2 sides, 2 layers (1 side, 1 layer)
(3) Super Audio CD :
12 cm, 1 layer / 12 cm, 2 layer / 12 cm, Hybrid
(4) Compact Disc (CD-DA) :
12 cm / 8 cm disc
(5) Memory device :
USB memory device (USB 2.0)
HDMI output : Output terminal : 19-pin HDMI terminals, 2 set
(Deep Colour, Dolby Digital Plus, Dolby TrueHD, DTS-HD, 3D)
Analog audio output : Output level : 2 Vrms (10 kΩ)
2 channels output terminal : Pin-jack, 1 set
Audio output characteristics : (1) Frequency response
q BD (Linear PCM)
w DVD (Linear PCM)
e Super Audio CD
r CD
: 2 Hz - 22 kHz (48 kHz sampling)
: 2 Hz - 44 kHz (96 kHz sampling)
: 2 Hz - 88 kHz (192 kHz sampling)
: 2 Hz - 22 kHz (48 kHz sampling)
: 2 Hz - 44 kHz (96 kHz sampling)
: 2 Hz - 88 kHz (192 kHz sampling)
: 2 Hz - 40 kHz
: 2 Hz - 20 kHz
(2) S/N ratio : 125 dB (BD)
(3) Total harmonic distortion : 1 kHz, 0.0008 % (BD)
(4) Dynamic range : 110 dB (BD)
n General
Power supply : AC 100 – 240 V, 50/60 Hz
Power consumption :
(vpage38 “Energy Saving Mode”)
25 W
0.3 W (Energy Saving Standby)
0.5 W (Normal Standby)
14 W (Quick Start)
z For purposes of improvement, specifications and design are subject to change without notice.
GRemote control unitH
Symptom Cause/Solution Page
The set cannot be
operated with the
remote control.
•Aim the remote control directly at the infrared sensor window on
the front of the unit.
•Operate within a distance of 7 m from the remote control sensor.
•Remove any obstacles.
•Replace the batteries with new ones.
•Insert the batteries in the proper direction, checking the q and
w marks.
•Match the signal code of the remote control to the signal code of
the unit.
•Check whether the remote sensor of the unit is exposed to direct
sunlight or strong light of a fluorescent lamp, 3D synchro signal of
TV. Be sure to avoid exposing the remote sensor to strong light.
49
49
49
49
49
41,50
49
The unit is operated
by the remote
control of an other
DENON product.
•The unit is designed to be operated by the remote controls of other
DENON products. To avoid the unit being operated by the remote
controls of other devices, set “Others” – “Legacy Remote” to
“Off” on the SETUP menu.
41
•Some functions may not be used under certain operating conditions, but this is not failure of the unit.
Read the description in this Owner’s Manual for details on correct operations.
•The volume may differ from disc to disc. This is due to the differences in how the signals are recorded
on the disc and is not a malfunction.
•During programmed playback, it is not possible to perform random playback or to start playback from a
desired track or file.
•Some functions are prohibited on some discs.