ENGLISH
ENGLISH
Getting Started Connections Specifications
DCD-CX3 (This unit)
Receiver
Audio timer
AC outlet (Wall)
Symptom Cause Measures Page
Using the timer play function
Also refer to the operating instructions of the audio timer.
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Is the set being operated as described in the operating instructions ?
3. Are the other components operating properly ?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
Disc tray does not open. • The power is not on. • Turn on the power. 8
“NO DISC” is displayed even
though a disc is loaded.
• The disc is not properly loaded. • Reload the disc.
3
“00 : 00” is displayed even though a
disc is loaded.
• A disc other than a CD or Super Audio CD is
loaded.
• Load a CD or Super Audio CD.
3
Playback does not start even when
the
1/3 button on the main unit or
the
1 button on the remote control
unit is pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 2, 3
No sound is produced or sound is
distorted.
• The output cables are not properly connected to
the receiver.
• The receiver’s function setting or adjustments are
not right.
• Check the connections.
• Check the receiver’s function and controls and
adjust as necessary.
7
–
No digital signals are output. • For Super Audio CDs, no digital signals are output.
• Turn the pure direct mode on.
• For Super Audio CDs, use the analog audio output
signals.
• Turn the pure direct mode off.
7
9
A specific section of the disc cannot
be played properly.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 2, 3
• The tracks have not been programmed properly. • Program properly.
9Programmed playback is not
possible.
• The disc has not been finalized.
• The recording conditions are bad or the quality of
the disc itself is poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
2
2
A CD-R or CD-RW disc cannot be
played.
• You have selected a copyright-protected WMA file
or a file that cannot be played normally.
• Press the
8 or 9 button to select a different
file.
11Files recorded in MP3 or WMA
format cannot be played.
• The batteries are spent.
• The remote control unit is too far from the set.
• Replace the batteries with new ones.
• Move the remote control unit closer to the set.
4
4
Set does not operate properly when
remote control unit is operated.
1
Turn on the power of the connected components.
2
Switch the receiver’s input function to the function to
which the player is connected.
3
Load a disc in the player.
4
Set the audio timer for the desired times.
5
Turn the timer “ON”.
• The power of the components connected to the timer turns
off.
b When the set time is reached, the power of the different
components automatically turns on and playback starts from the
first track.
ENGLISH
Operation Troubleshooting
To Next Page
