Denon DCM-340 - Note on Parts List

6 OCM-.449 0/24 0 aaa ee a a ee
26
NOTE FOR PARTS LIST
@ Part indicated with the mark" © " are not always in stock and possibly to take a long period of time for supplying, or in
some case supplying of part may be refused.
@ When ordering of part, clearly indicate "1" and "I" (i) to avoid mis-supplying.
@ Ordering part without stating its part number can not be supplied.
@ Part indicated with the mark "x" is not illustrated in the exploded view.
@ Not including Carbon Film +5%, 1/4W Type.in the P.W.Board parts list. (Refer to the Schematic Diagram for those parts.)
WARNING:
Parts marked with this symbol /\
@ Resistors
Ex: AN 14K 2& 182 G FR
Type Shape Power Resist- Allowable Others
and per- ance error
| formance | | |
; Carbon 3 H : Pulse-resistant type
: Composition : Low noise type
: Metal oxide film : Non-burning type
: Winding H : : Fuse-resistor
: Metat film H : : Lead wire forming
: Meta! mixture
+ Resistance
1 8 2 => 1800 ohm = 1.8 kohm
{ ‘tL. Indicates number of zeros after effective number.
2-digit effective number.
* Units: ohm
41 R 2 =» = 1.2 0hm
[ L___ 4-digit effective number.
2-digit effective number, decimal point indicated by R.
¢ Units: ohm
' * Capacity (electrolyte only)
22 2 = 2200F
[ tL... Indicates number of zeros after effective number.
2-digit effective number.
Units: pF.
2R 2 = 22yF
[ L—— 1-digit effective number.
2-digit effective number, decimal point indicated by R.
* Units: pF.
have critical characteristics.
Use ONLY replacement parts recommended by the manufacturer.
e@ Capacitors
Ex: CE 04W 1H 2R2 OM
BP
Type Shape Dielectric Capacity Allowable Others
and per- strength error
formance | co
: Aluminum foil : 121%
electrolytic
: Aluminum solid : 122%
electrolytic
: Tantalum electrolytic 4 125%
Flim 3 + £10%
: Ceramic Hy 1 420%
: Ceramic 7 2 +80%
: Oil : 20%
: Mica : 2+100%
: Metallized : ~0%
: Metallized : :20,25pF
: +0.5pF
: Others
* Capacity (except electrolyte) _
2.2 2 => 2200uyF = 0.0022uF
|
: High stability type
: Non-polar type
: Rippte-resistant type
: For charge and discharge
: For assuring high
frequency
: UL part
: CSA part
: UL-CSA type
: Lead wire forming
| t_«More than 2} Indicates number of zeros after effective number.
2-digit effective number,
Units: pF.
2 1 => 220PF
2
| Loo or 1)———— Indicates number of zeros after effective number.
2-digit effective number.
*Units: PF.
* When the dielectric strength is indicated in AC, "AC" is included after the dieelectric
strength value.