16
Control Commands
(Host → DN-700R)
CATEGORY CONTENTS CODE DESCRIPTION
Track Searching
Set Skip Back Time
@0SBNNN\r
Sets the number of seconds that a track will
rewind when Skip Back is executed, where NNN
(the number of seconds in multiples of 0.1) =
005–600 (0.5 second – 60 seconds)
Fast Forward (cyclic) @02352\r
Fast forwards the current track; each entry of the
command cycles through the fast forward
speeds (2x, 10x, 50x, 100x, and 200x)
Fast Forward (specific)
@02352n\r
Fast forwards the current track at a specific
speed, where n (the speed) = 1 (for 2x), 2 (for
10x), 3 (for 50x), 4 (for 100x) or 5 (for 200x)
Set Search Audibility @0sMXX\r
Determines whether audio will be heard while
fast-forwarding or rewinding at the 2x speed,
where XX = NO (audio will be heard) or SL (audio
will not be heard)
Activate Frame Mode @0frON\r
Enters DN-700R in frame search mode; after
entering frame search mode, the current track
will be paused, and the track will be audible
while skipping frame units
Frame Forward @0fr00\r Skips forward one frame unit in the current track
Frame Reverse @0fr01\r Skips back one frame unit in the current track
Skip Back to Mark @023M-\r
Skips back to the mark prior to the current
track’s playback position
Skip Ahead to Mark @023M+\r
Skips ahead to the mark after the current track’s
playback position
Cue @023CU\r
Skips to the track time position from which
playback was last started and pauses the track
Hot Start
Assignment
Load Hotlist
@0HLXXXX\r
Loads a hotlist file, where
XXX stands for the
hotlist file name
Assign Hot Start Number
(with 3-digit track file
number)
@0HSnnNNN\r
Assigns the track to the hot start number in the
currently loaded hotlist, where nn (the hot start
number) = 01–20 and NNN (the track file
number) = 001–999
Note: Enter 000 for NNN to cancel the hot start
number assignment
Assign Hot Start Number
(with 4-digit track file
number)
@hsnnNNNN\r
Assigns the track to the hot start number in the
currently loaded hotlist, where nn (the hot start
number) = 01–20 and NNNN (the track file
number) = 0001–2000
Note: Enter 0000 for NNNN to cancel the hot
start number assignment
Assign Hot Start Number
(with file name)
@0HsnnXXXX\r
Assigns the track to the hot start number in the
currently loaded hotlist, where nn (the hot start
number) = 01–20 and XXXX = the track file name
(absolute path required)
See Appendix > Entering the Absolute Path
for Folder and File Names for details on the
requirements for entering absolute paths
To Next Page
Loading...
Need help?
General
