Denon DN-HD2500 - Assembly Note

57
DN-HD2500
ASSEMBLY NOTE
Mounting the rubber buttons
BUTTON A : Ref. No. 43 BUTTON B : Ref No. 44
BUTTON C : Ref No. 45 BUTTON D : Ref No. 46
Use the buttons tagged “A” on the
side of the panel with the “A” stamp.
Use the buttons tagged “B” on the
side of the panel with the “B” stamp.
The 1P wire should pass
under the button.
The 1P wire should pass
under the button.
A
B
Be sure there is
no twisting.
Mount with the red
part on the left side
“A” stamp “B” stamp
Cut along the groove indicated
by the dotted line.
A
A
B
B
Cut along the groove indicated
by the dotted line.
After cutting, use the buttons
tagged “A” on the side of the panel
with the “A” stamp.
Note : The tags indicate the place of usage (A and B stamps).
After cutting, use the buttons
tagged “B” on the side of the panel
with the “B” stamp.