Denon DN-HD2500 - Version Upgrade Procedure of Firmware

17
DN-HD2500
VERSION UPGRADE PROCEDURE OF FIRMWARE
Use the procedure described below to update the firmware to a newer version.
No Mode Operation and Function Display

Store the file (file name : HD2500.BIN) for
updating the firmware in the root directory of
the built-in hard disk drive or USB device.
If the file for updating the firmware is stored on
a USB device, connect the USB device to the
USB A terminal.
Pressing the Deck1’s SOURCE ( ) but-
ton and Deck2’s BACK ( ) button simul-
taneously, turn on the power. The screen for
updating the firmware appears.
Specify the device containing the file for
updating the firmware.
If the file is on the built-in hard disk drive,
press the Deck1 CUE ( ) button.
If the file is on a USB device, press the Deck2
CUE ( ) button.
Specify the starting of updating the firmware.
If the file is on the built-in hard disk drive,
press the Deck1 PLAY/PAUSE ( ) but-
ton.
If the file is on a USB device, press the Deck2
PLAY/PAUSE ( ) button.
To cancel, turn the power off.
Be careful that the power does not get
turned off while the firmware is being
updated.
ファームウェアのバージョンアップ方法

No モード 操 作 と 機 能 表 示




    

  
   

      
  
  



     

  
  

    
  
   
  
  
バージョンアップ中は、電源が OFF にならな
いよう注意してください。