8
DN-HD2500
2.4
HDD_Format
mode
Turn the Deck1 or Deck2 PARAMETERS knob
to select "HDD_Format" from the FUNCTION
check mode's top menu, then press the
PARAMETERS knob to set "HDD_Format"
mode.
When the PARAMETERS knob is pressed, the
format confirmation message appears.
When the PARAMETERS knob is pressed, for-
matting starts and the internal hard disk is for-
matted in FAT32.
Note that when the hard disk is formatted,
all the data on the hard disk is erased irre-
trievably.
"Complete!!" is displayed when initialization is
completed normally, "Fail" is displayed if for-
matting is completed abnormally.
In the latter case, formatting is not possible in
this mode. Use a disk formatter (freeware or
other, for example symantec's "Norton Ghost",
operation not guaranteed) to format the disk in
FAT32.
When the BACK ( ) button is pressed
before formatting has been executed, the
FUNCTION check mode's top menu reap-
pears.
2.5
DRIVE_Check
mode
Connect the transmission and reception pins
of the DRIVE terminal to an external device
(loop back) and supply DC +5.5V to the power
terminal.
Turn the Deck1 or Deck2 PARAMETERS knob
to select "DRIVE_Check" from the FUNCTION
check mode's top menu, then press the
PARAMETERS knob to set "DRIVE_Check"
mode.
Data is transmitted from the DRIVE terminal
and whether or not the sent data can be
received is checked.
The checking status and results are displayed.
No Mode Operation and Function Display
The progress of
formatting and the
message indicating
that formatting has
been completed are
displayed here.
When the process
has completed
normally
When the process
has completed
abnormally
The checking status
and results are
displayed here.
When the process
has completed
normally
When the process
has completed
abnormally
フォーマットを行うと、ハードディスクの全
てのデータが消去されますので、ご注意くだ
さい。
No モード 操 作 と 機 能 表 示
To Next Page
Loading...
