Howling is produced
Howling is produced.
0
This unit and speaker are too close together. Move the speaker away from this unit.
0
This unit is in an unstable position. Install in a stable, level location.
0
Playback volume is too loud. Adjust the volume of the connected amplifier to the appropriate level.
The tone arm stops moving halfway
The tone arm not tracking during playback.
0
Make sure there are no scratches on the record.
0
Make sure nothing is obstructing the tone arm.
The platter does not rotate at the set speed
The platter does not rotate at the set speed.
0
The speed light blinks continuously when the platter is not rotating at the set speed. Unplug and reinsert the power cord, then press the START/STOP
button again. If this does not resolve the problem, contact our customer service center.
Contents
Preparations Connections Playback Tips Appendix
33
Front Rear
To Next Page
