Denon DRA-100

TECHNICAL SPECIFICATIONS
n
Audio section
• Power amplier
Rated output : 2-channel driving
35 W + 35 W (8Ω、1kHz T.H.D 0.01 %)
Dynamic power : 70 W + 70 W (4Ω、1kHz T.H.D 0.01 %)
Output connectors : Speaker：impedance 4～16Ω
Compatible with headphones / stereo headphones
Input sensitivity/Input impedance : 200 mV / 22 kΩ
Total harmonic distortion (1kHz、17.5W、8Ω) : Analog In：0.04 %
S/N ratio (35W、8Ω、IHF-A) : Digital In : 110dB
Tone control : Bass：±8dB(100Hz)
Treble：±8dB(12 kHz)
Frequency response : Analog In：20Hz～96kHz
n
Wireless LAN section
Network type (wireless LAN standard) : Conforming to IEEE 802.11b
Conforming to IEEE 802.11g
Conforming to IEEE 802.11n
(Wi-Fi® compliant)z1
Security : WEP 64 bit, WEP 128 bit
WPA/WPA2-PSK (AES)
WPA/WPA2-PSK (TKIP)
Radio frequency : 2.4 GHz
No. of channels : 1 - 13 ch (for E2, JP)
z1 The Wi-Fi® CERTIFIED Logo and the Wi-Fi CERTIFIED On-Product Logo
are registered trademarks of the Wi-Fi Alliance.
n
Bluetooth section
Communications system : Bluetooth Version 2.1 + EDR
(Enhanced Data Rate)
Transmission power : Maximum 2.5 mW (Class 2)
Maximum communication range : Approx. 32.8 ft/10 m in line of sightz2
Frequency band : 2.4 GHz band
Modulation scheme : FHSS (Frequency-Hopping Spread Spectrum)
Supported proles : A2DP (Advanced Audio Distribution Prole)1.2
AVRCP (Audio Video Remote Control Prole)1.4
Corresponding codec : SBC, AAC
Transmission range (A2DP) : 20 Hz - 20,000 Hz
z2 The actual communication range varies depending on the inuence of
such factors as obstructions between devices, electromagnetic waves
from microwave ovens, static electricity, cordless phones, reception
sensitivity, antenna performance, operating system, application
software etc.
n
General
Power supply : (for E2) : AC 220 - 230 V, 50 Hz / 60 Hz
(for JP) : AC 100 V, 50 Hz / 60 Hz
Power consumption : 60 W
Power consumption in standby mode : 0.3W
Power consumption in "Network Control" –"On" mode : 3W
For purposes of improvement, specications and design are subject to
change without notice.
9