Getting Started Getting Started
4
ENGLISH
Remote control unit
Remote control signal
transmitter ························(2)
Power buttons················(12)
Volume control
buttons ····························(12)
MUTING button··············(12)
Indicator ··························(22)
System buttons··············(23)
[ Front ]
MENU button ·················(11)
Cursor buttons
(
DD
,
HH
,
FF
,
GG
) ····················(17)
PURE DIRECT button ·····(13)
DIMMER button··············(13)
VIDEO SELECT
button······························(13)
ENTER button···········(11, 18)
CHANNEL buttons ·········(14)
Mode selector
switches ··············(12, 20, 22)
Function buttons············(12)
STATUS button ··············(13)
SHIFT button ··················(14)
NOTE:
• If buttons on the front or rear are pressed strongly, the button on the opposite side will be activated
too.
¢
System remote control unit (RC-1052)
Rear panel
q
AUDIO OUT terminals·································(7)
w
SUBWOOFER PRE OUT terminal ···············(6)
e
AUDIO IN terminals·····························(6, 7, 9)
r
ZONE PRE OUT terminals···························(9)
t
TRIGGER OUT jacks ··································(10)
y
ZONE VIDEO OUT terminals ······················(9)
u
Speaker terminals ·······································(6)
i
AC outlets···················································(10)
o
AC inlet ·······················································(10)
!0
AUDIO PRE OUT / MAIN IN terminals ····(10)
!1
VIDEO IN terminals ·····································(7)
!2
VIDEO OUT terminals ·····························(6, 7)
!3
RS-232C terminal·······································(10)
!4
SIGNAL GND terminal ································(7)
!5
XM terminal ·················································(8)
!6
DOCK CONTROL jack ··································(9)
!7
ANTENNA terminals ···································(8)
!8
REMOTE CONTROL jacks ···························(9)
To Next Page
Loading...
