Paths to be conî™°rmed Display Settings What to conî™°rm
5
Analog AD
(MAIN ZONE)
î™°g.A05a
î™°g.A05b
A06:AD
Input Source : CBL/SAT
Input Mode : Analog (î™°xed)
Sound mode : STEREO
Vol 60(-20dB)
MAIN ZONE : On
ZONE2 : Off
• Analog input ⇒ Speaker output (Front L/R, Center, Surround L/R)
• Analog input ⇒ SW(20Hz)
(
b
The input source can be switched to any source except CBL/SAT.)
(
b
Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
6 Analog ZONE2 î™°g.A06
A07:ANALOG-Z2
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : STEREO
Z2 Source : CBL/SAT(select a setting other than Source)
Vol 60(-20dB)
MAIN ZONE : On
ZONE2 : On
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
(
b
Source for ZONE2 does not change even when Source for the main zone is changed.)
(
b
The input source for ZONE2 can be switched to any source except CBL or SAT.)
(
b
Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
7 Speaker B î™°g.A07
A12:SPEAKER-B
Input Source : CBL/SAT
Input Mode : Analog (î™°xed)
Sound mode : DIRECT
Speaker Select : B
MAIN ZONE : On
ZONE2 : Off
• Analog input ⇒ Speaker output (Left/Right B)
(
b
The input source can be switched to any source except CBL/SAT.)
8 ZONE2 Downmix
î™°g.A08a
î™°g.A08b
A22:Z2 Downmix
Input Source : CBL/SAT
Input Mode : Auto
ZONE2 Source : Source
ZONE2 Vol : 60
MAIN ZONE : On
ZONE2 : On
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
(
b
The input source can be switched to any source except CBL/SAT.)
(Leave the ZONE2 Source as Source.)
(
b
Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
114
To Next Page
Loading...
