Denon DRA-800H - Page 115

1.6. Conrmation items for the video system
See the block diagram g.VXXth.
Paths to be conrmed Display Settings What to conrm
1 HDMI pass g.V01
V03:HDMI PASS
Input Source : CBL/SAT
MAIN ZONE : On
ZONE2 : Off
• HDMI input ⇒ HDMI output (MAIN)
(
b
The input source can be switched to any source except CBL/SAT.)
2 HDMI CEC g.V02
V04:HDMI CEC
Input Source : CBL/SAT
HDMI Control : On
MAIN ZONE : On
ZONE2 : Off
• Check that the stereo receiver enters standby when the TV is set to Standby via HDMI OUT.
(
b
The input source can be switched to any source except CBL/SAT.)
• The ARC path can also be checked (check this using the TV input source).
3
HDMI Audio
(Audio : Stereo
Receiver)
g.A04a
g.A04b
V05:H.AUDIO-Amp
Input Source : CBL/SAT
HDMI Control : Off
HDMI Audio : Stereo Receiver (if checking the audio
output from Stereo Receiver)
• HDMI input (PCM) ⇒ Speaker output
(
b
The input source can be switched to any source except CBL/SAT.)
4
HDMI Audio
(Audio : TV)
g.V03
V06:H.AUDIO-TV
HDMI Audio : TV (if checking the audio output from TV) • HDMI input (PCM) ⇒ HDMI output (audio output from connected TV)
(
b
The input source can be switched to any source except CBL/SAT.)
5 GUI g.V04
V07:GUI MENU ON
Input Source : CBL/SAT
Setup Menu : On
MAIN ZONE : On
ZONE2 : Off
• GUI display ⇒ HDMI output.
(
b
The input source can be switched to any source except CBL/SAT.)
Before Servicing
This Unit
Electrical Mechanical Repair Information Updating
115