No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Layout” – “Subwoofer” on the menu to “Yes”. (v p. 142)
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. (v p. 127)
0
Switch to a sound mode other than “Direct” or “Pure Direct”. (v p. 100)
No sound is output when using ZONE2.
0
The analog audio signal and the 2-channel PCM signal input from digital connectors (OPTICAL/COAXIAL) can be played back in ZONE2.
0
When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a
range of about 98.4 ft/30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
0
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
Contents
Connections Playback Settings Tips Appendix
177
Front panel Display Rear panel Remote Index
To Next Page
Loading...
