34
PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC
The procedure after replacing the u-COM (Microprocessor), ash ROM, etc. is as follows.
PWB
Name
Ref. No. Description
After
replaced
Remark
CONTROL
IC100 STM8S207M8T6 B 704-6K2-A620
CONTROL
IC105 IC(EN25F1-100GIPTR) B 417-DDJLE-1084
After replacing
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the version.
C : The software has not been written. The software needs to be written after replacement. See “Firmware Update
Procedure” for information on writing the software.
D : The software has been written. Be sure to rewrite with the latest software for your service region. See “Firmware
Update Procedure” for information on writing the software.
FIRMWARE UPDATE PROCEDURE
1. Items to Be Prepared
(1) Connect the computer by USB cable.
MC6000MK2 : Type B
(2) UPDATER
Dowload Dennon SDI site.
for Windows : DDJUpdater-2.0.msi
for Mac : DDJ Updater.app
(3) Latest Firmware
Dowload Dennon SDI site.
le : MC6000MK2_vX.YYY
(X.YYY: Ver.No.)
2. InstallingthermwareupdateprogramforWindows
b
Upgrade program for Macintosh is installed on your Mac by copied the DDJ Updater.app.
(1) Double click the DDJUpdater-2.0.msi
MC3000
To Next Page
Loading...
Need help?
General
