Listening to music via a digital
connection (COAXIAL/OPTICAL-1/
OPTICAL-2)
1
Use INPUT SELECT df to switch the input source to
“COAXIAL”, “OPTICAL-1” or “OPTICAL-2”.
The digital audio signal that is being input is shown as follows in the
display.
.
(xxxx is the sampling frequency.)
0
If the sampling frequency cannot be detected, “Unlocked” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
2
Play back music on the connected device.
The speakers output music from the connected device.
o
Audio signals that can be played back
See “D/A Converter” (v p. 50).
NOTE
0
Do not input non-PCM signals, such as Dolby Digital and DTS. This causes noise
and could damage the speakers.
Contents Connections Playback Settings Tips Appendix
29
Front panel Display Rear panel Remote Index
To Next Page
Loading...
