o
Sound is distorted or interrupted, or noise occurs
Symptom Cause / Solution Page
Sound is distorted or
interrupted, or noise
occurs.
0
Adjust to an appropriate volume level on this unit and the connected devices. 27
0
Place the device connected via Bluetooth closer to this unit. －
0
Place this unit away from microwaves, wireless LAN devices, etc. －
0
Turn off and on power to Bluetooth devices. －
0
Turn down the volume of the playback device connected to the AUX connector. －
0
Switch “H/P AMP Gain” to “High” if using headphones with high impedance or low sensitivity. 39
o
Desired sound does not come out
Symptom Cause / Solution Page
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected. 19
0
Set the left/right volume balance using “Balance” in the setup menu. 39
The left and right of stereo
sound is reversed.
0
Check whether the left and right speakers are connected to the correct speaker terminals. 20
Set values are not reflected
in “Bass”, “Treble” and
“Balance”.
0
Set “Off” to the “Source Direct”. 39
Headphone volume is low.
0
Switch “H/P AMP Gain” to “High” if using headphones with high impedance or low sensitivity. 39
Contents Connections Playback Settings Tips Appendix
46
Front panel Display Rear panel Remote Index
To Next Page
Loading...
