Denon PMA-A110 - Playback via USB-DAC on Computer; Selecting USB-DAC Input Source; Starting Computer Software Playback

G
Select the “PMA-A110” format.
0
It is normally recommended to set the format to “384000.0 Hz” and
“2ch-32 bit Interger”.
.
⑦
PMA-A110
PMA-A110
H
Quit Audio MIDI Setup.
o
Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
(v p. 20)
1
Press INPUT SELECT to switch the input source to
“USB-DAC”.
Start playback on the computer’s player software.
0
If the sampling frequency cannot be detected, “Unlocked” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
36
Front panel Rear panel
Remote control
unit
Index