13
Press S1 button after bag replacement - bag reset
RED LED (right)
ON: Error (Mains power o / Battery low) or Fault.
Blinking: Empty bag or low fluid.
OFF: No error condition.
EMPTY
RESERVE
ARM
HEATING
BLU LED (center)
ON: Unit is armed and ready to shoot (if green led is already ON).
OFF: Unit is disarmed, shot not possible.
GREEN LED (left)
ON: Unit has reached the correct temperature.
Blinking: Unit is warming, no shot possible.
OFF: Device fault.
The EMPTY signal also means that fluid is going LOW.
It means that the unit has shot at least 240 seconds since last reset (Density
®
Basic).
13. Front leds meaning
IMPORTANT!
When inserting a new refill or replacing an empty one, you must RESET the fluid measurement system.
To do this simply hold the RESET button (S1 Button) for 3-4 seconds until the confirmation green led blinks.
To Next Page
Loading...