Denver DAB-37 - Factory Reset Procedure

ENG-14
4. Use the ‘Station +’ and ‘- Station’ buttons to scroll to the display language
you would like. Press and release the ‘Select’ button.
Note: As soon as you select a different display language, all of the display
information will be in this new language.
5. Press and hold the ‘Info/Menu’ button to return to the station display.
Software version
1. Press and hold the ‘Info/Menu’ button on the top of your radio.
2. Use the ‘Station +’ and ‘- Station’ buttons to scroll to <System>.
Press and release the ‘Select’ button.
3. Use the ‘Station +’ and ‘- Station’ buttons to scroll to <SW version>.
Press and release the ‘Select’ button.
4. The software version will be displayed and you may wish to make a
note of it here:
.................................................
5. Press and hold the ‘Info/Menu’ button to return to the station display.
Factory reset
You can reset your radio and restore all of the original factory settings.
Note: If you reset your radio all of your DAB and FM station presets will
be deleted.
1. Press and hold the ‘Info/Menu’ button on the top of your radio.
2. Use the ‘Station +’ and ‘- Station’ buttons to scroll to <System>.
Press and release the ‘Select’ button.
3. Use the ‘Station +’ and ‘- Station’ buttons to scroll to <Factory Reset>.
Press and release the ‘Select’ button.
4. ‘Factory Reset? <No> Yes’ will be displayed. Use the ‘Station +’ and
‘- Station’ buttons to scroll to ‘<Yes>’. Press and release the select’
button to confirm.
5. ‘Restarting...’ is displayed. After a few seconds the display will change to
‘Welcome to Digital Radio’ and will then go to Standby.
6. Press and hold the ‘ ’ button on the top of the radio and your radio will
switch on and scan for DAB stations. Remember to extend the
telescopic aerial.