ENG-9
Using your FM radio
FM mode
Press and release the ‘DAB/FM’ button on the top of your radio until ‘FM’
is displayed.
When your radio is in FM mode it can receive Radio Data System or ‘RDS’
information if this is being transmitted by the broadcaster. RDS information
will often include the station name, detail about the programme and the
current time.
If you were listening to an FM station when you switched the radio off
then this station will be automatically selected when you switch the radio
back on.
Telescopic aerial
Please make sure that the aerial on the top of the radio is fully extended
and adjusted before you attempt to tune to an FM station. This will ensure
that the maximum signal strength is available when the radio begins to
scan. Extending the aerial also ensures the best possible sound quality.
Tuning to an FM station
1.
Press and release the ‘Scan’ button on the top of your radio to scan up
the frequency band. Press and hold the ‘Scan’ button to scan down the
frequency band. Your radio will search for the next available station
and then stop on that station.
2.
Use the ‘Station +’ and ‘-Station’ buttons to fine tune each frequency.
The RDS information for each station will be displayed, if available.
Note: If reception is still poor adjust the position of the aerial or try
moving the radio to another location.
Storing an FM station preset
Your radio can store up to 9 FM stations in its preset memories for
instant access to your favourite stations.
Note: When you store FM radio station presets, these do not overwrite
your DAB station presets.
1.
Tune your radio to the station that you wish to preset (see Tuning to
an FM station on this page).
To Next Page
Loading...