8. Bluetooth playback
- 17 -
Before transmission between your Bluetooth device and the radio is
possible, both devices must be coupled. This process is called "pairing".
The Tuner is served as a receiver, to receive music stream to play on the
Tuner. Check the BT antenna already installed.
If you have already coupled to a Bluetooth device before, this connection
will be restored automatically when both devices are in range and
Bluetooth operation has been selected on the radio. "Pairing" does not
have to be repeated. This function may need to be activated in your
Bluetooth device, however.
•
Push the button to display the selection menu for the different
operating modes.
•
Use the up / down button to select the operating mode Bluetooth and push
the dial switch.
•
Switch your Bluetooth device to which you want to connect the radio on
and activate the pairing mode here. The device scans for Bluetooth
devices in the reception range.
•
When the radio is found, your bluetooth device shows its name MA-03-
XXXX (the XXXX is an identification code for your radio unit).
•
Select the radio at your bluetooth device.
•
Start playback on your bluetooth device.
•
Playback now takes place using the radio.
To Next Page
Loading...