11. Configuration
- 20 -
Here you will find the complete settings / options available to configure your
own tuner. On the main menu, navigate to Configuration setting. Press OK
and you will see a list of options available.
Network
•
Wireless Network
» Add wireless network
Scan & select ─ It will scan out a list of wireless networks around.
WPS button─ Choose this option to connect your Wi-Fi router via WPS
if the router has a WPS button.
» Remove wireless network
If you have already set up a network and want to remove it, choose this
option.
Note ─ Always bring the Tuner within 2 meters of the Wi-Fi router for
setup.
» AP: [ ]
If you have added more than one network on the radio and want to
switch to another one, select this option to change.
» Signal
This is to show the strength of the wifi Signal of the wifi router as
received by the radio. Usually signal levels lower than -70dBm is at
weaker level and if it affects the reception of your radio, you may need
to optimize the router location or check any problem of the router itself.
» IP
The IP is set Dynamic by default. Select to change Fixed IP according
to your network condition.
» DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS
according to your network condition.
•
Network Options
Always on: The WLAN function remains switched on (faster access
when switching from DAB or FM mode to Internet radio).
Auto off in 15s/30s: The WLAN function shuts down after 15s/30
seconds when not in use (to save energy).
•
Wireless Channels
Not all of the Wireless channels are available in every country. There
may be variation between different countries. Therefore it is necessary
to choose the Wireless channels to ensure the Wi-Fi performs
To Next Page
Loading...