______________________________________________________________________________
DESMI Pumping Technology A/S 6
Tagholm 1
9400 Nørresundby – Denmark
Tel: +45 96 32 81 11 Fax: +45 98 17 54 99
E-mail: desmi@desmi.com
www.desmi.com
09 : With bare shaft end.
10 : Special-tailored according to task.
Any use of the pump is to be evaluated on the basis of the materials used in the pump. In
case of doubt, contact the supplier.
Pumps in material combinations A and C are primarily used for fresh water.
Pumps in material combination D are primarily used for sea water.
2.3 TECHNICAL DESCRIPTION
The noise level indicated is the airborne noise including the motor. The noise depends on the
motor type supplied, as the noise from the pump can be calculated as the noise level of the
motor + 2dB(A).
The capacity of the pump appears from the name plate on the pump. If the pump has been
delivered without motor, the pump capacity is to be indicated on the plate when mounting the
motor.
The permissible loads on the flanges appear from the following table:
To Next Page
Loading...
Need help?
General
