4.1 95-862014
DeVice repAir AnD retUrn
Prior to returning devices, contact the nearest local
Detector Electronics office so that a Return Material
Identification (RMI) number can be assigned. A
written statement describing the malfunction must
accompany the returned device or component to
assist and expedite nding the root cause of the
failure.
Pack the unit properly. Always use sufficient packing
material. Where applicable, use an antistatic bag as
protection from electrostatic discharge.
NOTE
Inadequate packaging that ultimately causes
damage to the returned device during shipment
will result in a service charge to repair the damage
incurred during shipment.
Return all equipment transportation prepaid to the
factory in Minneapolis.
NOTE
It is highly recommended that a complete spare
be kept on hand for eld replacement to ensure
continuous protection.
orDerinG informAtion
Sensor module, Transmitter module, and termination
boxes (if used) must be ordered separately.
Refer to the UD20 Model Matrix for ordering details.
REPLACEMENT PARTS/ACCESSORIES
Part Number Description
009700-001 Magnetic Tool
009793-002 Electronics Module
010253-001 250 ohm Terminating Resistor Kit
101197-001* Stop Plug, 3/4" NPT, AL
101197-004* Stop Plug, 3/4" NPT, SS
101197-005 Stop Plug, M25, AL, IP66
101197-003 Stop Plug, M25, SS, IP66
010816-001 Stop Plug, 20PK, 3/4" NPT, AL, EX D
010817-001 Stop Plug, 20PK, 3/4" NPT, SS, EX D
010818-001
Stop Plug, 20PK, M25, AL, IP66, EXDE
010819-001
Stop Plug, 20PK, M25, SS, IP66, EXDE
104190-001 Stop Plug, M25, AL, INMETRO
104190-002 Stop Plug, 3/4” NPT, AL, INMETRO
104190-003 Stop Plug, M25, SS, INMETRO
104190-004 Stop Plug, 3/4” NPT, SS, INMETRO
102804-001 Reducer, M25 to M20, AL
102804-003 Reducer, M25 to M20, SS
103922-001 475 Field Communicator
005003-001 Lubriplate grease, 1 oz.
107427-040 O-ring - Viton
104371-001 Bartec Self-Regulating Heating
Cable System
* NEMA 4/IP66 rating requires addition of non-hardening
thread sealant or Teflon tape.
MODEL DESCRIPTION
UD20 Universal Display Unit
TYPE MATERIAL
A Aluminum
S Stainless Steel (316)
TYPE THREAD TYPE
5M 5 PORT, METRIC M25
5N 5 PORT, 3/4” NPT
TYPE OUTPUTS
26 Pass-Through 4-20 mA, HART
TYPE APPROVAL
W FM/CSA/ATEX/IECEx
B INMETRO (Brazil)
TYPE CLASSIFICATION (Div/Zone)
2 Ex d (Flameproof)
UD20 MODEL MATRIX
To Next Page
Loading...
