Deutz TCD 2013 2V - Page 50

5
© 02/2010 OBJ_DOKU-21742-001.fm
11/12
Job card overview
TCD 2013 2V Sorted numerically
W 41-01-01 Removing and installing the exhaust line Exhaust pipe
W 43-01-01 Removing and installing the turbocharger Exhaust gas turbocharger
W 44-02-01 Removing and installing the generator (V-belt drive) Generator
W 44-03-01 Removing and installing the starter Starter
W 46-00-01
Mounting engine on assembly block and demoun
-
ting
Engine mounting
W 47-01-01
Removing and installing the engine mounting
(elastic mounting)
Engine mounting
W 48-01-01 Removing and installing the cable harness Cable harness
W 48-02-01
Removing and installing the impulse transmitter
(crankshaft)
Electrical equipment
W 48-02-03
Removing and installing the impulse transmitter
(camshaft)
Electrical equipment
W 48-03-01
Removing and installing the pressure/temperature
sensor (charge air)
Electrical equipment
W 48-04-01 Removing and installing the oil pressure switch Electrical equipment
W 48-05-01
Removing and installing temperature transmitter
(coolant)
Electrical equipment
W 48-06-01 Removing and installing the fuel pressure sensor Electrical equipment
W 49-02-01 Installing and removing turning gear Tools
W 49-02-02
Installing and removing turning gear (Torsional vib
-
ration damper)
Tools
W 52-01-01 Removing and installing the connection housing Connection housing
W 52-01-02 Check alignment of connection housing Connection housing
W 63-01-01 Removing and install the heating flange Start aid
W 63-02-01 Removing and installing the glow plugs Start aid
Job card Activity Maintenance group