Devatec ElectroVap - Change Settings Menu

ElectroVap RTH-V2
40
Pictures and values are not contractual - The devices may be subject to changes without notice
5 - Software assistant
ou
HUMIDIFIER
STATUS
V : X.XX.XXX
RTH: XXX 3X400V
AQUASTAT
HEATING
LEVEL SENSORS CHECK
INITIAL
PRODUCTION CYCLE
STEAM PRODUCTION
XXX lbs/h XXX kg/hrs
FILLING TANK
IN PROCESS
HUMIDIFIER
SETUP
VALUE OF CTRL
XX.X V
ROOM RH: XX %
SET POINT: XX %
ou
ou
ou
ou
RTH : VERSION CODE
If the tank is empty: it displays that the tank lling is in
process
If Aquastat is “ON”= Frost protection
Test: levels sensors
During shutdown phases only and when water is below
xx ° C, preheating is enabled
Steam production ( lbs/h et kg/h )
Display signal control
Appears when a sensor is used:
Display of the relative humidity (RH) as well as the setpoint
5.1 MENU INFORMATION
or
or
or
or
or