Need help?Do you have a question about the Devatec ElectroVap and is the answer not in the manual?
General introduction to the ElectroVap ELMC humidifier and safety instructions.
Explains safety symbols and general warnings for safe operation and handling.
Manual details, intended use, and maintenance by qualified personnel.
Guidelines for storage, water types, and electrical installation requirements.
Details warranty period, conditions, and manufacturer's liability limitations.
Overview of the ELMC humidifier's design, compatibility, and standard delivery contents.
Guidance on suitable water types and recommendations for water supply.
Important considerations for connecting the water supply, including pressure and temperature.
Explanation of absorption distance and its importance for steam dispersion.
Method and table for calculating the required absorption distance based on humidity.
Guidelines for positioning steam dispersion pipes after the minimum absorption distance.
Specific positioning instructions for steam dispersion pipes in vertical ducts.
Guidance on tilting dispersion pipes in ducts with limited height.
Guide to selecting the appropriate steam hose based on model and output.
Conditions for operating humidifiers with pressure higher than atmospheric pressure.
Best practices for installing steam hoses, including length and slope.
Table of maximum amperage requirements for different voltage and steam production rates.
Wiring diagrams for connecting a remote information board and dry contacts.
Instructions for connecting to the RS485 interface and configuring the SW1 switch.
Communication parameters for MODBUS RTU and BACNET MSTP protocols.
Detailed mapping of Modbus registers and Bacnet classes to device functions and values.
Wiring for ON/OFF control signals and dip switch settings.
Wiring for proportional control signals and dip switch settings.
Wiring for humidity sensor control and dip switch settings.
Wiring for digital control signals and related settings.
Regular checks, warnings about deposits, and troubleshooting electric arcs.
Specific checks to perform if electrical arcs appear inside the cylinder.
Step-by-step procedure for safely replacing the steam cylinder.
Detailed method for cleaning the steam cylinder components and electrodes.
Part numbers and descriptions for water inlet valve components.
Part numbers and descriptions for draining circuit components like valve body and coil.
General| Brand | Devatec |
|---|---|
| Model | ElectroVap |
| Category | Humidifier |
| Language | English |
To Next Page
