ELECTROVAP® ELMC
19
3.6 DRAIN HOSE CONNECTION
The following drawing shows the drain hose connection that should be made.
Use a Ø 25 mm rubber drain hose with the 2 supplied hose clamps, heat-resistant (up to 100°C).
Connect the hose to the draining system. Regular replacement is recommended.
If rigid piping is used, it must be a heat-resistant PVC material (up to 100 °C).
The discharge hose must be free from any obstacle.
It is recommended that each humidifier has its own drain pipe.
If possible, use a collecting water tank with a lid (see the picture below).
To Next Page
Loading...
