© 2012 ITW Finishing Systems and Products 3
EC Declaration of Conformity
We, ITW Finishing UK, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the
manufacturer of the Spray gun model GTIPRO LITE, declare, under our sole responsibility that
the equipment to which this document relates is in conformity with the following standards or
other normative documents:
BS EN 12100 PARTS 1 & 2: 2010, BS EN 1953: 1998+A1:2009; and thereby conform to
the protection requirements of Council Directive 98/37/EEC relating to Machinery Safety
Directive, and;
EN 13463-1:2009, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 G X.
This product also complies with the requirements of the EPA guidelines, PG6/34. Transfer
efficiency certificates are available on request.
D Smith, General Manager
2
nd
February 2012
ITW Finishing Systems and Products reserve the right to modify equipment specification without prior notice.
Part Numbers
The ordering code for the GTIPRO LITE Spray gun is;
E.g. PROPL-TE30-12 where;
P = Pressure or S for Suction
TE30 = TE30 Air cap
12 = 1.2mm Nozzle
See charts 1 & 2 p13 for available Air cap / Nozzle sizes
Operational Description
This GTIPRO LITE Spray Gun is a professional quality gun designed with both high volume, low
pressure (HVLP) technology or High Efficiency EPA compliant technology. HVLP Technology
reduces overspray and limits air cap pressure to 0.7 bar (10 psi). High Efficiency complies with
EPA by obtaining transfer efficiency above 65%.
IMPORTANT: These Spray guns are suitable for use with both water-based and solvent-based
coating materials. These guns are not designed for use with highly corrosive and/or abrasive
materials and if used with such materials it must be expected that the need for cleaning and/or
replacement of parts will be increased. If there is any doubt regarding the suitability of a specific
material, contact your DeVilbiss Distributor or DeVilbiss direct.
NOTE: This gun is not to be used with halogenated hydrocarbon solvents or cleaning agents
such as 1,1,1,-Trichloroethane or methylene chloride. These solvents can react with the
aluminium components used in this gun and cup. The reaction can become violent and lead to
an equipment explosion.
To Next Page
Loading...
