● Sleeping mode: Touch the sleep button, the button lights up and the sleep function will be
activated. Press and hold the sleep button for 3 seconds to reset the filter.
Timer
Press the timer button to set the 0-12-hour timing function. The timer can only be set in 1-hour
increments. Each time you press this button, the value increases by 1 hour and then the
corresponding timing value is displayed on the screen. The setting value is “00” to cancel the
timer function. After the timer is set and completed, the timer LED is on during the timing period.
After the timer is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine.
In the standby state, set the time to turn on the machine.
Note: pressing POWER will also cancel the shutdown timer setting.
Speed
The speed can only be adjusted in automatic mode. Touch the speed button to switch between
high and low fan speed.
Up
Press this button to set the humidity and timer;
Humidity adjusting the order of 30% to 35% - 40% - 45% - 50% - 55% - 60% - 65% - 70% - 75% - 80% - 30%;
To set the timer press the timer button and 00 will flash on the digital display, then press the key repeatedly
until you reach your desired time.
Down
Press this button to lower the humidity setting or timer time;
Humidity adjusting the order of 30% to 80% - 75% - 70% - 65% - 60% - 55% - 50% - 45% - 40% - 35% - 30%;
When setting the timer, if you accidently go beyond your desired time you can use the down button to cycle
backwards.
Child-lock
When the machine is turned on, press the button for 3 seconds to open/close the child lock function. When
the button is turned on, the indicator light of the child lock is on. When the child lock function is active it will be
cancelled automatically if the device is shutdown or a power failure occurs.
WIFI（Optional）--Timer key
Information on the App “Smart Life-Smart Living”
The “Smart Life-Smart Living” app is available for android and iOS.
To Next Page
Loading...
