Operating methods
Description of functions
Setting of timer off
⚫
When the dehumidifier is running, press the [Timer button] to adjust time
from 1h to 24h, pressing the key once to increase the setting time by 1h,
after the setting time exceeds 24h, the figure returns to 1 to restart
cycle.This will then turn the dehumidifier off after this desired set time. After
an hour has been selected, if the Timer button is untouched for 5 seconds,
the set time is confirmed.
Setting of timer on
⚫
When the dehumidifier is in standby state, the method for adjustment of
setting time by the [Timer key] is the same as timer off. After the setting is
completed, if the Timer button is untouched for 5 seconds, the set time is
confirmed. When the timer is in use the Timer button should be illuminated,
and the set time is displayed on control panel.
AUTO mode
⚫
Select AUTO dehumidification, if the room humidity is higher than the set
humidity or is between +5% or -5% of the set humidity , the compressor
will starts and the fan will run at the set speed. If the room humidity is lower
than the set humidity by -5%, then the compressor will stop but the fan will
run at the set speed. The default set humidity value is 50%.
CONTINUOUS mode
⚫
Select CONTINUOUS dehumidification to keep the dehumidifier operating
no matter what low the relative humidity in the room is. The compressor
starts, the fan runs at high speed in default, and the air speed can be
regulated via the air speed button.
Internal Drying
◆
Press the Internal Drying button to start drying in the dehumidifier.
The whole drying procedure needs approximately 1h:
1.
The dehumidifier starts at HIGH air speed continuously for 30min
2.
The dehumidifier turns to run at LOW air speed and lasts for 20min;
◆
How to stop:
1.
Press the button again to cancel drying in dehumidifier, and return
to the running state before start of drying.
2.
Press the Power button to stop drying in dehumidifier and return to the
standby state.
Child lock function
Hold the Mode button for 3 seconds to enable and then the same again to
disable this feature. All keys on the operation panel will then be disabled while
Child Lock is activated.
To Next Page
Loading...
