Devolo Magic 2 LAN triple - Reset and Restart Procedures

19 Introduction
devolo Magic 2 LAN triple
2.2.5Reset/Restart
Restart
The device restarts if you press the PLC/reset but-
ton for less than 10 seconds.
Reset—Factory default settings
1 To remove a devolo Magic adapter from your
devolo Magic network and successfully restore
its entire configuration to factory defaults,
press and hold the PLC/reset button longer
than 10 seconds.
Be aware that this loses all changes to all set-
tings!
2 Wait until the LED flashes white and then dis-
connect the devolo Magic adapter from the
power supply.
The devolo Magic adapter has been suc-
cessfully removed from your existing
devolo Magic network.