Initial use 24
devolo Magic 2 LANtriple
3.5 Removing the devolo Magic
adapter from a PLC network
To remove a devolo Magic adapter from your net-
work and successfully restore its entire configurati-
on to the factory default settings, press the PLC/
reset button longer than 10 seconds.
Wait until the LED flashes white and then dis-
connect the adapter from the power supply.
Be aware that this loses all changes to all set-
tings!
To integrate it into another network, proceed as
described in Chapter 3.3.2 Single—Expanding an
existing PLC network by adding another
devolo Magic 2 LAN triple.
To Next Page
Loading...
