Network configuration 30
devolo Magic 2 LANtriple
b Simply using the PLC button (see Chapter 3.3
Connecting the devolo Magic adapters)
b Using the web interface, in the PLC menu; as
described below:
Pairing—Using on-screen button
1 Click Start pairing to start the pairing opera-
tion. This may take some time.
2 As soon as the new devolo Magic adapter is
integrated into your existing network, it
appears in a list of available and established
connections.
Pairing—Using a custom password
You can also assign your network a custom PLC
password. Enter this password for each
devolo Magic adapter in the Powerline password
field and confirm your settings by clicking the Disk
icon.
Note that the custom password is not assigned
to the whole PLC network automatically. In-
stead, you must assign it to each of your
devolo Magic adapters individually.
Powerline domain name
The Powerline domain name determines the name
of your PLC network.
Unpairing—Removing an adapter from a net-
work
1 To remove a devolo Magic adapter from your
devolo Magic network, click Leave Powerline
network.
2 Wait until the LED flashes red and then dis-
connect the devolo Magic adapter from the
power supply.
Compatibility mode
Using as VDSL connection may negatively impact
the performance of the broadband connection.
Select from among the following settings in order
to mitigate any potential negative effects.
Operating mode:
b MIMO
b SISO
Signal transmission profiles:
b Full power
b VDSL 17a (default)
b VDSL 35b
To Next Page
Loading...
Need help?
General
