Introduction 18
devolo Magic 2 LANDINrail
Ethernet (Fig. 2)
*Information about the web interface can be
found in Chapter 5 Configuration.
2.3.4PLC button
devolo Magic adapters that are in factory default
condition, i.e. have been purchased or successfully
reset (see Chapter Resetting a devolo Magic ad-
apter or removing it from a devolo Magic net-
work), automatically start to attempt to pair with
another devolo Magic adapter when reconnected
to the mains supply.
Expanding an existing devolo Magic network
by adding another devolo Magic adapter
In order to use a new devolo Magic 2 LAN DINrail
in your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
devices as a network. This is accomplished by using
a shared password, which can be assigned in va-
rious ways:
b Using devolo Cockpit or the
devolo Home Netwok App (see Chapter 4.2
Installation of devolo software)
Ether-
net-LED
Flashing beha-
viour
Meaning LED status display
(web interface*)
1White
LED
Lights up steady Connection to the Ethernet network Cannot be disabled
2White
LED
Flashes Data transmission Cannot be disabled
3White
LED
Off Standby mode Cannot be disabled
To Next Page
Loading...
Need help?
General
