Devolo Magic2 LAN DINrail User Manual

19 Introduction
devolo Magic 2 LAN DINrail
b Using the web interface (see Chapter 5.2.2
Powerline)
b Using the PLC button (see Fig. 2)
2.3.5Reset button
Reboot
The device is restarted by shortly pressing the reset
button (Fig. 2).
Resetting a devolo Magic adapter or removing
it from a devolo Magic network
To remove a devolo Magic adapter from your
devolo Magic network and successfully restore its
entire configuration to the factory default settings,
press and hold the reset button longer than
10 seconds. Wait until the PLC LED flashes white
and then disconnect the devolo Magic adapter
from the mains supply.
Keep in mind that all settings that have already
been made will be lost!
To integrate the mains supply into another net-
work, proceed as described in Chapter 4.1 Expan-
ding an existing network.

Devolo Magic2 LAN DINrail Specifications

General

Product Type	Powerline adapter
Maximum Data Transfer Rate	2400 Mbps
Operating Temperature	0°C to 40°C
Mounting	DIN rail
Encryption	128-bit AES
Frequency Range	2-86 MHz
Operating Frequency	50/60 Hz
Device Type	Powerline
Operating Voltage	100-240 V
Storage Temperature	-25°C to 70°C
Humidity	10-90% non-condensing
Certifications	CE, RoHS
Standards	HomePlug AV2, IEEE 1901