Devolo MicroLlink - Page 13

|
Control commands
13
|
devolo MicroLink ISDN i
|
EN
$ICLI Setting the outgoing multiple subscriber number (MSN)
$ICLI Suppression of caller ID display
$IDBS Setting the data block length
$IDP D-channel protocol setting
$IEAZ Setting the terminal selection digit (EAZ)
$IMSN Call acceptance from multiple subscriber numbers (MSNs)
$IRES Reset ISDN settings
$ISCI Service characteristics for incoming analog calls
$ISCO Service characteristics for outgoing analog calls
-M0
-M1
Plain text CONNECT messages dependent on AT\V
Plain text CONNECT messages independent of AT\V
O Transition to online status
\Pmn Storing dial numbers (m = 0 to 9)
Q0
Q1
Q2
Return of messages from ISDN terminal adapter on
Return of messages from ISDN terminal adapter off
Messages off in answer mode
*Q0
*Q1
CONNECT message after invalid escape sequence
No CONNECT message after invalid escape sequence
\Q0
\Q1
\Q2
\Q3
\Q4
No handshake
Bidirectional XON/XOFF handshake
Unidirectional CTS handshake
Bidirectional RTS/CTS handshake
Unidirectional XON/XOFF handshake
Sn=x
Sn?
Sn
?
=x
Sets register n to value x
Reads the value of register n
Sets pointer to register n
Reads value of last register used
Sets value of last register used to x
\S Display of the current settings
\Tn Inactivity timer
$UPX Firmware upload in flash ROM
V0
V1
Messages in short form as a digit
Messages in plain text
%V Display of firmware version
&V Display configuration profiles
Command Meaning