Devolo MicroLlink - Page 18

AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
18
EN
sequent call answering can be enabled despite DTR = OFF by setting bit 7 in
register S28.
\D DSR/CTS control
*AT\D0 : DSR and CTS always active
AT\D1 : DSR tracks transmission channel
and CTS always active
AT\D2 : DSR always active and CTS tracks DCD
AT\D3 : DSR tracks transmission channel
and CTS tracks DCD
This command affects the significance of the signal lines DSR and CTS. If
hardware flow control is used, the AT\D command setting has no effect on
the CTS signal line in the transmission phase.
E Command Echo to Host
ATE0 : Commands not echoed
*ATE1 : Commands echoed
This command permits the choice of whether the MicroLink ISDN i returns the
input commands as an echo or not.
&F Load default configuration
AT&F
This is used to load the firmware's default parameter settings. The MicroLink
ISDN i is thus reset to its factory defaults. This command is not executed dur
-
ing existing connections.
The dial-number memory, charge statistics, configuration profiles and ISDN
settings are not reset by the command AT&F, however.