|
AT commands: Detailed description
19
|
devolo MicroLink ISDN i
|
EN
\F Display of stored telephone numbers
AT\F
This command lists the calling numbers in position 0 to 9 that were stored by
means of the AT\P and AT&Z commands.
H Hang up
ATH
This command is used to hang up an existing connection if the MicroLink
ISDN i is in the command mode after an escape command or a DTR transition
from ON to OFF with a preceding AT&D1.
H2 Call rejected
ATH2
If ATH2 is input in response to an incoming RING, the caller receives the mes-
sage “call rejected”.
I Report version number
ATI0 : Report product code in nnn format
ATI1 : Report checksum
ATI2 : Report checksum result (OK or ERROR)
ATI3 : Report version number and firmware
release date
ATI4 : Display of current parameters
ATI5 : Report serial number and hardware
release
To Next Page
Loading...
