Devolo MicroLlink - Page 20

AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
20
EN
ATI6 : Display product name
ATI7 : Report self-test result
ATI9 : Report Plug & Play ID text
$I? Display of current ISDN parameters
AT$I?
Use this command to display the modem's current ISDN configuration.
$IBP Setting the B-channel protocol
AT$IBP=<Wert1>
This command is used to select the operating mode of the MicroLink ISDN i.
The ISDN modem attempts to establish an error-corrected X.75 connection by
default. If the remote station does not support X.75, the adapter automati
-
cally falls back to HDCLP mode via V.120:
Parameter Value Description
<Value1> X75 X.75 protocol
X75T70 T.70NL protocol
V120 V.120 protocol
V110 V.110 protocol
HDLC HDLC protocol
TRANS Transparent
HDLCP HDLC-PPP protocol
BTX X.75, T.70NL and Cept/Kit
X75FB1 X.75 → HDLCP
X75FB2 X.75 → V.120 → HDLCP
X75FB3 X.75 → V.120
V120FB1 V.120 → HDLCP