Devolo MicroLlink - Page 21

|
AT commands: Detailed description
21
|
devolo MicroLink ISDN i
|
EN
Example
To establish an error-corrected V.120 connection with the MicroLink ISDN i,
enter the following command:
AT$IBP=V120
The default value for the MicroLink ISDN i is X75FB2.
$IBR Setting the ISDN bit rate
AT$IBR=<Value1>
This command is used to select the desired bit rate on the ISDN side. The
MicroLink ISDN i operates at a transmission speed of 64,000 bps by default.
$ICI Charge information
AT$ICI? : Display charge information
AT$ICI=p,0: Delete charge information for port
This command is used to display the total connect charges, as well as the
connect charges for the previous connection. The charges could be displayed
as follows:
$ICI:=0,113,1 (113 = total charges, 1 = last call on port 0).
The current-charge display is automatically reset to 0 after the next dialing
process. The total-charge information can be deleted with the command
AT$ICI=0,0.
Parameter Value Description
<Value1> 64000 ISDN bit rate 64,000 bps
56000 ISDN bit rate 56,000 bps
Parameter Value Description
p 0 Port 0 (V.24 interface)