AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
22
EN
$ICLI Setting and suppressing your own
calling number
AT$ICLI=p,"MSN",i
Use this command to stop your own multiple subscriber number (MSN) being
transmitted to the other party. The following settings are valid:
Example
If the calling number is not to be transmitted, enter the following command:
AT$ICLI=0,"",0
By default no calling number is entered on the MicroLink ISDN i.
$IDBS Setting the data block length
AT$IDBS=<Value1>,<Value2>,<Value3>
This command is used to set the data block length. It can be used to ensure
compatibility to other B-channel protocols. The following settings are valid:
$IDP Setting the D-channel protocol
AT$IDP=<Value1>
Parameter Value Description
p 0 Port 0 (V.24 interface)
i 0 MSN is suppressed
1 MSN is transmitted
Parameter Standard Description
<Value1> 2048 Data block length for X.75 (4-2048) bytes
<Value2> 2048 Data block length for HDLCP and HDLC
(1-2048) bytes
<Value3> 259 Data block length for V.120 (5-259) bytes
To Next Page
Loading...
