|
AT commands: Detailed description
25
|
devolo MicroLink ISDN i
|
EN
The dial number is entered in Germany without the use of the local or national
codes.
Example
To assign the dial number 12345 to the modem for MSN1, enter the following
command:
AT$IMSN=0,"12345"
To change MSN3 only, enter the following command:
AT$IMSN=0,,,"12347"
The MSN can be deleted with the command AT$IMSN=0,"". No MSN is
assigned to the MicroLink ISDN i by default.
$IRES Reset of ISDN settings
AT$IRES
This command is used to reset all ISDN settings to factory default.The current
ISDN configuration of the terminal adapter may be displayed using the AT$I?
command.
$ISCI Service characteristics for incoming
analog calls
AT$ISCI=p,<Value1>,<Value2>,<Value3>,<Value4>
This command is used to determine which incoming analog calls will be
answered. Modifications must be saved using the AT*W or AT&W com
-
mands. The following settings are valid:
Parameter Value Description
p 0 Port 0 (V.24 interface)
<Value1> 0 Telephone service (3.1 kHz telephone service) off
1 Telephone service (3.1 kHz telephone service) on
<Value2> 0 Telephone service (analog telephone service) off
1 Telephone service (analog telephone service) on
To Next Page
Loading...
