Devolo MicroLlink - Page 26

AT commands: Detailed description
|
|
devolo MicroLink ISDN i
|
26
EN
Example
To set the MicroLink ISDN i for Group 3 fax operation, enter the following
command:
AT$ISCI=0,0,0,0,1
$ISCO Service characteristics for outgoing
analog calls
AT$ISCO=p,<Value1>
This command is used to set the bearer capability for outgoing calls. You may
select the terminal devices (e.g. telephone or fax) which are to be addressed.
Modifications must be saved using the AT*W or AT&W commands. The fol
-
lowing settings are valid:
Example
To set the MicroLink ISDN i for Group 3 fax operation, enter the following
command:
AT$ISCO=0,3
The MicroLink ISDN i is set to the value 1 (telephone service (analog tele-
phone service)) by default.
<Value3> 0 Group 2 fax operation off
1 Group 2 fax operation on
<Value4> 0 Group 3 fax operation off
1 Group 3 fax operation on
Parameter Value Description
Parameter Value Description
p 0 Port 0 (V.24 interface)
<Value1> 0 Telephone service (3.1 kHz telephone service)
1 Telephone service (analog telephone service)
2 Group 2 fax operation
3 Group 3 fax operation